Manuals / Toshiba / TV and Video / TV VCR Combo

Toshiba MV13P2 Continued, Remote Control, Battery Installation, Battery Precautions, Feet

Models: MV13P2

1 56

Download 56 pages 21.65 Kb

Page 12

BATTERY INSTALLATION

REMOTE CONTROL

BATTERY INSTALLATION

1	Slide the battery compart-	2	Install two “AAA” batteries,
1	ment cover in the direction	2	paying attention to the
	of the arrow.		polarity diagram in the
			battery compartment.

BATTERY PRECAUTIONS

(CONTINUED)

3	Replace the compartment
3	cover.

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture (Follow battery manufacturer’s directions).

EFFECTIVE DISTANCE OF THE REMOTE CONTROL

15 FEET

NOTES: • When there is an obstacle between the TV/VCR and the remote control, the remote control may not operate.

•When direct sunlight, an incandescent lamp, ﬂuorescent lamp or any other strong light shines on the Remote sensor of the TV/VCR, the remote operation may be unstable.

•When using the remote control, press the button at intervals of about 1 second to ensure the correct mode of operation.

10

5L80101C P10-19

10

20/4/04, 16:19

Image 12

Toshiba MV13P2 owner manual Continued, Remote Control, Battery Installation, Battery Precautions, Feet

Contents

MV13P2 TELEVISION/VCR COMBINATIONOWNER’S MANUAL Reorient or relocate the receiving antenna IMPORTANT SAFEGUARDS 5. CLEANING8. ACCESSORIES 10. POWER SOURCEIMPORTANT SAFEGUARDS CONTINUED 12. POWER-CORD PROTECTION14. POWER LINES 19. REPLACEMENT PARTSIMPORTANT RECYCLING INFORMATION 20. SAFETY CHECK22. NOTE TO CABLE TV SYSTEM INSTALLER EXAMPLE OF ANTENNA GROUNDING AS PER THE NATIONAL ELECTRICAL CODEFEATURES TABLE OF CONTENTS PREPARATIONTV OPERATION PLAYBACKSAFETY PRECAUTIONS WHAT IS MOISTURE CONDENSATION?WHEN YOU EXPERIENCE THE ABOVE CONDITIONS MOISTURE CONDENSATIONPOWER SOURCE TO USE AC POWERLOCATION OF CONTROLS FRONTREAR 1516REMOTE CONTROL 18. REC and TIMER REC buttons19. VOLUME + / - andB / A cursor buttons 23. COUNTER RESET button - Used to reset the counter toCONTINUED REMOTE CONTROLBATTERY INSTALLATION BATTERY PRECAUTIONSANTENNA CONNECTIONS CABLE TV CONNECTIONS FOR SUBSCRIBERS TO BASIC CABLE TV SERVICEFOR SUBSCRIBERS TO SCRAMBLED CABLE TV SERVICE STARTING SETUP 1 2CANCEL ENTERSETTING THE LANGUAGE POWERCANCEL MENUAUTO CLOCK SETTING AUTO CLOCK SETTINGAUTO CLOCK ADJUSTMENT TO SET AUTO CLOCK TO OFFAUTO CLOCK SETTING DAYLIGHT SAVING TIME SETTINGCONTINUED MANUAL CLOCK SETTING 1 2 3 4POWER as in step 3, then pressTV OPERATION TV mode direct channel selectionCABLE mode direct channel selection VHF/UHF/CABLE CHANNELSCALL VOL +MUTE CH +TV OPERATION CONTINUEDSLEEP CLOSED CAPTIONWHAT IS CLOSED CAPTIONING? CLOSED CAPTIONING WITH A VCRTO VIEW CLOSED CAPTIONS TO MEMORIZE CHANNELS Cable TV chartTV/CABLE SELECTION AUTOMATIC MEMORY TUNING POWERCANCEL MENUTO MEMORIZE CHANNELS CONTINUEDTO ADD/DELETE CHANNELS channel selectionSETTING THE V-CHIP TO REGISTER PASSWORDEnter the same password using Direct channelSETTING THE V-CHIP 1 2CONTINUED TO SET THE V-CHIPENTER Parental guidanceParental guidance To use the TV after the TV is protectedSETTING THE V-CHIP TO CHANGE PASSWORDCONTINUED TO SET THE ON TIMER 1 2 13 4 5 2 3 4TO SET THE OFF TIMER 3 4 52 3 4 PICTURE CONTROL ADJUSTMENTS CANCEL1 2 SelectionADJUSTING THE PICTURE PREFERENCE ModePicture Quality LOADING AND UNLOADING A VIDEO CASSETTE AUTOMATIC POWER ON AND PLAYLOADING UNLOADINGLOADING AND UNLOADING A VIDEO CASSETTE CONTINUEDTO PREVENT ACCIDENTAL ERASURE TO RECORD AGAINPLAYBACK TO START PLAYBACKSTOP TO STOP PLAYBACKPLAYBACK CONTINUEDDIGITAL TRACKING CONTROLS TO REWIND OR FORWARD THE TAPE RAPIDLYSPECIAL PLAYBACK TO VISUALLY SEARCH FOR DESIRED POINTSSPEED SEARCH TIMES STILL PICTURESPECIAL PLAYBACK CONTINUEDTO WATCH A TAPE REPEATEDLY Press or to select “AUTO REPEAT”RECORDING A TV PROGRAM RECORDING AND VIEWING THE SAME TV PROGRAMRECORDING A TV PROGRAM CONTINUEDTO STOP RECORDING TO STOP RECORDING TEMPORARILYONE-TOUCH TIMER RECORDING OTR Press Direct channelTIMER RECORDING 1 2 4Press or to select “TIMER REC SET” Press the or to select the programTIMER REC indicator will light TIMER RECspeed as in step 6 Press ENTEROTHER FUNCTIONS FOR THE TIMER RECORDING CANCELTO CANCEL A PROGRAM TO SET DAILY/WEEKLY TIMERUSING THE REAL TIME TAPE COUNTER TO VIEW THE COUNTER DISPLAYdisplay the elapsed time USING ZERO RETURN Before playback or recording, press“000000” Press ZERO RETURNVIDEO INDEX SEARCH SYSTEM/TO MONITOR A TV PROGRAM Index searchRecording an INDEX mark DUPLICATING A VIDEO TAPE CONNECTION TO ANOTHER VCRCONNECTION TO CAMCORDER RECEPTION DISTURBANCES CARE AND MAINTENANCEIGNITION GHOSTSPROBLEM AND TROUBLESHOOTING GUIDE Check the following chart before requesting serviceSYMPTOM POSSIBLE SOLUTIONSYMPTOM POSSIBLE SOLUTIONREMOTE CONTROL CAUSEVIDEO HEAD CLEANING SPECIFICATIONSVIDEO HEAD CLEANING GENERAL Power source Power consumption DimensionsLimited Ninety 90 Day Warranty Limited One 1 Year WarrantyLimited Two 2 Year Warranty of Picture Tube Rental UnitsHow to Obtain Warranty Service Toll FreeATTENTION CANADIAN CONSUMERS In the Continental United States contact