Introduction
Identification of controls (Continued)
Inserting batteries
Open the battery compart- | Install two “R03/AAA” batteries | 3 | Replace the compartment |
ment cover in the direction of | (supplied), paying attention to the | cover. | |
1 the arrow. | 2 polarity diagram in the battery |
|
compartment.
Caution:
Never throw batteries into a fire.
Notes:
•Be sure to use AAA size batteries.
•Dispose of batteries in a designated disposal area.
•Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accord- ance with applicable laws and regulations.
•If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with new ones.
•When necessary to replace batteries in the remote control, always replace both batteries with new ones. Never mix battery types or use new and used batteries in combination.
•Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment.
Remote control basics
•Press POWER to turn the unit on or off.
•Select your desired operating mode (TV/VCR or DVD) using TV/VCR or DVD.
•Tap CH 
or 
to move through the channels one channel at a time.
•The Direction buttons (
/
/
/ 
) are also used to navigate
•You can directly access specific channels using Direct channel selection buttons.
Illustration of MW20F52
Operation:
•Aim the remote control at the remote sensor and press control buttons to operate.
•Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5 meters.
Approx. 5 meters
12
5W70101A | 12 | 30/1/06, 2:29 PM |
