Toshiba MW20F52, MW24F52 SAFETY PRECAUTION/ Power source, Location of the required Marking

Models: MW24F52 MW20F52

1 72
Download 72 pages 38.12 Kb
Page 5
Image 5
SAFETY PRECAUTION/ Power source

SAFETY PRECAUTION/ Power source

WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the distance between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance with the FCC (Federal Communications Commission) Rules could void the user's authority to operate this equipment.

CAUTION:

Location of the required Marking

The rating sheet and the safety caution

THIS DIGITAL VIDEO PLAYER EMPLOYS A LASER SYSTEM.

are on the rear of the unit.

 

TO ENSURE PROPER USE OF THIS PRODUCT, PLEASE READ

 

THIS OWNER'S MANUAL CAREFULLY AND RETAIN FOR FU-

 

TURE REFERENCE. SHOULD THE UNIT REQUIRE MAINTE-

 

NANCE, CONTACT AN AUTHORIZED SERVICE LOCATION.

 

USE OF CONTROLS, ADJUSTMENTS OR THE PERFORMANCE

 

OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN

 

MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

VHF/UHF

 

DIGITAL AUDIO

TO PREVENT DIRECT EXPOSURE TO LASER BEAM, DO NOT

 

TRY TO OPEN THE ENCLOSURE. VISIBLE LASER RADIATION

CERTIFICATION: COMPLIES WITH

MAY BE PRESENT WHEN THE ENCLOSURE IS OPENED. DO

FDA RADIATION PERFORMANCE

NOT STARE INTO BEAM.

STANDARDS, 21 CFR SUBCHAPTER J.

 

WARNING: This product contains a laser beam. Do not attempt to stare at the beam through the DVD disc tray or the ventilation openings. Staring directly at the beam may cause permanent damage to your eyesight.

Introduction

IMPORTANT RECYCLING INFORMATION

This product uses both Cathode Ray Tube (CRT) and other components that contain lead. In your community there might be regulations that require you to dispose these materials

properly under environmental considerations. Please contact your local authorities, or the Electronic Industries Alliance (http://www.eiae.org) for disposal or recycling information.

Power source

AC Outlet

Wider Hole

and Blade

Polarized AC Cord Plug

(One blade is wider than the other.)

TO USE AC POWER SOURCE

Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a standard 120V 60Hz polarized AC outlet.

Notes:

Never connect the AC line cord plug to other than the specified voltage (120V 60Hz). Use the attached power cord only.

If the polarized AC cord does not fit into a non-polarized AC outlet, do not attempt to file or cut the blade. It is the user’s responsibility to have an electrician replace the obsolete outlet.

If you cause a static discharge when touching the unit and the unit fails to function, simply unplug the unit from the AC outlet and plug it back in. The unit should return to normal operation.

If the AC cord plug is plugged in for the first time, wait for approx. 5 seconds before pressing the POWER button.

5

5W70101A [E]p02-05

5

30/1/06, 2:28 PM

Page 5
Image 5
Toshiba MW20F52, MW24F52 SAFETY PRECAUTION/ Power source, Location of the required Marking, To Use Ac Power Source