Preparation of the remote control
Insert the specified battery to the remote control. See page 8 , 9 for safety use of
onsi | 1 Gently insert a fingernail in groove q | |
and pull out the holder in direction w. | ||
Preparat | ||
Backside | ||
| ||
| 1 | |
| 2 |
Take care not to break your fingernail.
Operating with the remote control
Point the remote control at the remote sensor and press the buttons.
Within about 3 m (9.9 feet)
Distance: About 3 m (9.9 feet) from the front of the remote
2Place a
Keep the holder horizontal so that the battery does not fall through.
|
|
| |
|
| ||
|
| ||
| 6 | ||
2 |
|
| |
# |
| ||
sensor
Angle: About 30° in each direction of the front of the remote sensor
Do not expose the remote sensor of the player to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the player via the remote control.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or equivalent type.
3Insert the holder into the remote control.
The remote control battery contains Perchlorate Material - special handling may apply.
24http://en.wikipedia.org/wiki/perchlorate
・Aim the remote control at the remote sensor of the player.
・Do not drop or give the remote control a shock.
・Do not leave the remote control near an extremely hot or humid place.
・Do not spill water or put anything wet on the remote control.
・Do not disassemble the remote control.
・If the remote control does not function correctly or if the operating range becomes reduced, replace the battery with new one.
・Inserting a battery other than the specified one or an object may damage the remote control.
