AUTOMATIC OPERATION (Auto Changeover)
When you set the air conditioner in 
mode or switch over from AUTO operation because of some settings change, it will automatically select either cooling, heating, or fan only operation depending on the indoor temperature.
3
Start
1 | ON / OFF | button |
|
TEMP. |
| ON / OFF |
TIMER SET | FAN | MODE |
TIME | SWING/FIX | VENT |
FILTER |
|
|
RESET TEST SET CL | UNIT |
|
1
2
2
3
Push this button to start the air conditioner.
Mode select button (MODE)
Select Auto.
Temperature button
Set the desired temperature.
•In case of cooling, start the operation after approx. 1 minute.
•In case of heating, the operation mode is selected in accordance with the room temperature and operation starts after approximately 3 to 5 minutes.
•When you select the Auto mode, it is unnecessary to set the fan speed. The FAN speed display will show AUTO 
and the fan speed will be automatically controlled.
•After the heating operation has stopped, FAN operation may continue for approx. 30 seconds.
•When the room temperature reaches the set temperature and the outdoor unit stops, the supper low wind is discharged and the air volume decreases excessively. During defrost operation, the fan stops so that cool
air is not discharged and “HEAT READY 
” is displayed.
•If the Auto mode is uncomfortable, you can select the desired conditions manually.
NOTE
When restarting the operation after stop
•When restarting the operation immediately after stop, the air conditioner does not operate for approx. 3 minutes to protect the machine.
Stop
Push 
ON / OFF button.
Push this button again to stop the air conditioner.
7
