ADJUSTMENT OF WIND DIRECTION
•When the air conditioner stops, the flap (adjustment plate of up/down wind direction) directs downward automatically.
•When the heating operation is in READY states, the flap (adjustment plate of up/down wind direction) directs upward. The swinging starts after HEAT READY status cleared, SWING is displayed on the remote controller even if the heating operation is in READY status.
How to set up the wind direction
1 Push SWING/FIX during operation.
The wind direction changes for every push of the button.
In HEAT operation
Direct the flap (adjustment plate of up/down wind direction) downward. If directing at upward, hot air may not come to the foot.
Initial setup
In COOL/DRY operation
Direct the flap (adjustment plate of up/down wind direction) upward. If directing it downward, the dew may from on the surface of the air discharge port and may drop down.
Initial setup
How to start swinging
1 Push SWING/FIX, set the flap (adjustment plate of up/down wind direction) direction to the lowest position, and then push SWING/FIX again.
SWING is displayed and the up/down wind direction is automatically selected.
How to stop swinging
1 Push SWING/WIND again while the flap is swinging.
•The flap stops at a position when you push. After then, if pushing SWING/FIX, the wind direc- tion descends from the highest position.
•In COOL/DRY operation, the flap does not stop as it directs downward.
If stopping the flap as it directs downward during swing operation, it stops after moving to the 3rd position from the highest position.
TEMP.
| TIMER SET |
| TIME |
FILTER |
|
RESET TEST | SET CL |
In FAN operation
Initial setup
ON / OFF
FAN MODE
SWING/FIX VENT
UNIT
In all modes
Series of operation
Display when stopping the swing
Fan/HeatCool/Dry
operationoperation
8