PROGRAMMING PROCEDURES-INTRODUCTION SECTION 100-816-301 MARCH 1993 TABLE 1 -C PROGRAM 90 INITIALIZING PROGRAMS 00 - 97 See Program 90 System Record Sheet
Press...
Step BUTTONS + LED keys
# Action description LCD RESPONSE . . .
1. Use an LCD digital or electronic telephone with a NO. OF STATION (10 - 29)
programming template. JAN 20 SUN 06:30
2. *#*#1*2*3 PROGRAM MODE
Enter programming mode.
3. SPKR 9 0 HOLD PROGRAM = 90
Access Program 90. System beeps after SPKR DATA STORE
button is pressed to indicate the program number
can be entered.
4. SPKR 90 SELECT =
Prepare system for the programs to be initialized.
5. 0 0 * 9 7+ LED keys 01 & 02 90 SELECT = 00*97
Enter program numbers individually or in a range. DATA CLR
For a range, separate the low program number and
the high program number with an asterisk.
NOTE:
To initialize only one program, enter the two digit
program number followed by a # ( [10 #), then press
Key 01 & 02.
6. HOLD (LEDs 01 and 02 flash rapidly) 90 SELECT = 00*97
Secures data in system programming. LEDs 01 DATA PROGRAMMED
and 02 flash.
7. SPKR
Prepare system for another selection (go back to
step 5), or exit Program 90 (continue with step 8).
90 SELECT =
8. # # HOLD 90 SELECT = ##
Secure Program 90 data in system memory. DATA PROGRAMMED
9. SPKR PROGRAM =
Exit Program 90. Enter another program number or exit
programming mode (go to step 10).
System beeps to indicate it’s exiting Program 90.
10. # # HOLD NO. OF STATION (10 - 29)
Exit programming mode. JAN 20 SUN 06:42
NOTE:
The system will not allow the SPKR
LED to light to reenter the programming mode.
1-7