Toshiba T2 Series Parity check For No Parity, the following settings are required, Off On

Models: T2 Series

1 24

Page 19

For No Parity, the following settings are required.

•EVN is off.

DLY

HAD

BR2

BR1

BR0

PEN

EVN

Page 13

Image 19

Contents

USERS MANUAL − Modbus Module −TOSHIBA CORPORATION PROSEC T2-SeriesImportant Information Safety Precautions Safety PrecautionsHazard Classifications About This Guide Contents Page 1. Overview Modbus Module 2. System Configuration1 to 1 Configuration Modbus MasterModbus Master 1 to N ConfigurationPage 3. External Features and Switch Settings4. Specifications T2 COMMAND 5. Modbus Module Operation 5.1. Modbus CommandsMODBUS FUNCTION CODE Modbus No 5.2. Modbus Data Types and T2 Register MappingData Type AttributeModbus - T2 Address mapping Example 5.3. Restricted Registers6.1. Modbus Module DIP Switch Settings 6. Modbus Module SetupStation Number 4800 Transmission Rate Baud RateBaud Rate 9600NONE ASY and DLY switchesParity Check PARITYFor 9600 baud, the following settings are required BR2 is on Example Configuration SettingsSet the Station number on the rotary switch to Set the HAD switch to OFF because our address is less thanASY DLY HAD BR2 BR1 BR0 PEN EVN 4 Parity check For No Parity, the following settings are requiredSwitch settings for 9600 baud, no parity, and address less than PEN is off EVN is off6.2. Wiring Connection to the Modbus Module 7. CPU Setup for the Modbus Module If the LED indicators are not flashing, check the following 8. Trouble ShootingIf the LED indicators are on solid 9. Additional References TOSHIBA TOSHIBA INTERNATIONAL CORPORATIONTOSHIBA CORPORATION TOSHIBA do BRASIL, S.A