Toshiba T2E manual Free ASCII mode, Data link mode, ommunication Port on the CPU Module

ommunication Port on the CPU Module

Free ASCII mode

User defined ASCII messages can be transmitted

and received through this port, A terrmirial, printer, bar-code reader, or other serial ASCII device can be

directly connected-

This mode allows the T2E/T2N to communicate with other PLCs (TI, T2E . T2N, etc), Inverters (such as VF-S7/A5, G3), or Motor protection relays (S2E21) .

Trarsrnission system	Half-duplex
Transmission code	ASCII
Transmission speed	30G/600{120tI/2410I
	4800/9 0119200 bps
i Framing	Start bit:	1 bit
	Data bits. 7 or F bits
	Parity,	Odd/even/none
Message €e gth	Stop bit :	1 or 2 bits
	512 bytes max .

Mote} RS-4 25 2-w-a system a alto rrEUlablc,

RS-485 (1 km max.)

Bar-code reader,	.T11:	i
		JI
Printer, etc-	I
	Micro PLO T1

Inverter VF-$7

#,Actor Protecdori Relay 521521

Data link mode

Two PI-Cs (any combination of T2 E, T2 N1 or Super T1-4D) oars be directly linked together . This direct link is inexpensive, easily configured and requires no special programmirtg- File registers F0000 to F0031 are used for the data transfer .

T2E or T2N

Transmission speed	10200 bpi
Protocol	Special
Link cata capacity	15 words (station 1 to 2)
	16 words {station 2 to 1)
Link data update time	approx . 50 rrts
	(not synchronized with
	T2E/T2N's scan)
	T2E Qr T2N

Station No .1	... ... ... ... .. ... ... ... . ... .. ... .. ... .. ... .. ... .. ... .. ... .. .. . ... .. ... ... ... ... ..Station No-2
FOD00		F0000
F0015	. . . . . . . . . . .	F0015
F0016		F0016
F0031		F0031

8