Names of the terminals on the rear panel
Preparing and using the remote control
(1) (2) (3)
(4) (5)(6) | (7) | (8) | (9) | (10) |
| Name | : Main Function |
(1) | COMPUTER (Y/PB/PR) 2 IN terminal | |
|
| RGB: Input analog RGB signal from a computer or other |
|
| source, or a component video signal (Y/PB/PR) from video |
|
| equipment. |
|
| AUDIO IN: Input audio signals. |
(2) | COMPUTER (Y/PB/PR) 1 IN terminal | |
|
| |
Loading dry-cell batteries into the remote control
1Remove the battery cover.
2Insert the dry-cell batteries.
Be sure to align the plus and minus ends of the batteries properly.
Two batteries (LR03, SIZE AAA) are used.
3Replace the battery cover.
Operating the remote
control
Point toward the projector’s infrared remote sensor, and press any button on the remote control.
• Operating the projector from the front
Approx. 15°
When operating the remote control from behind the projector, the signal beam is reflected on the projecting surface and may travel a shorter distance to reach the projector depending on the shape and material of the projecting surface.
Preparations
|
| component video signal (Y/PB/PR) from video equipment. |
| AUDIO IN: Input audio signals. | |
(3) | : Input S video signals from video equipment. | |
(4) | AC IN socket | : Connects the supplied power cord here. |
(5) | CONTROL terminal | : When operating the projector via a computer, connect this |
|
| to the controlling computer’s |
(6) | Main power switch | : AC power line ON (standby)/OFF. |
(7) | MONITOR terminal | : Connect to a computer display, etc. |
(8) | AUDIO OUT terminal | : Outputs audio signals. |
(9) | AUDIO (L/R) terminal | : Input audio signals from video equipment. (Dual use for |
|
| VIDEO and |
(10) | VIDEO terminal | : Input video signals from video equipment. |
Dry-cell batteries
•Before using the batteries, be sure to observe the Safety Precautions described in previous pages.
•Remove batteries from remote control when not using for extended periods.
•If the remote control stops working, or if its range decreases, replace all the batteries with new ones.
•Keep the batteries away from the reach of children.
Batteries are choking hazards and can be very dangerous if swallowed. If the batteries are swallowed, seek medical assistance immediately.
The remote control
•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.
•Do not drop or bang.
•Do not leave in hot or humid locations.
•Do not allow it to get wet or place it on top of wet objects.
•Do not take apart.
•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.
18 | 19 |
