Basic operations
1Turn on the power.
Turn on the power by following the instructions in “Turning the power on” p.24 .
2Select the language and the lamp power (When using the first time).
When the projector is used for the first time after purchase, the start menu for language (to display the menus and messages on the screen) and lamp power selection and configuration is displayed in English. (If the screen is out of focus, adjust it according to the step 6 .)
1Use the 
, 
, 
or 
button to select the desired language and press the 
button.
Notes
•When [Auto input search] is set to [Off] in the Default setting 1 menu p.41 (factory setting is [On]), the Input select menu appears if you press the INPUT button p.41 .
•If no signal is being output from the connected equipment, pressing the INPUT button does not change the input and “There is no other input signal.” will appear.
5Projector placement angle adjustments
The placement angle and the height of the projected image can be adjusted by the foot adjuster.
1 Lift up the front of the projector to the desired angle, then press the foot
English
French
German
Italian
Spanish
Portuguese
Russian
Swedish
Turkish
Polish
Norwegian
Finnish
Czech
Hungarian
Greek
Danish
Dutch
Rumanian
Japanese
Chinese (simplified)
Chinese (traditional)
Korean
Indonesian
adjuster release button.
The foot adjuster extends. Release the button to lock the position.
2To fine adjust the angle, twist the foot
adjuster.
3 To adjust the horizontal angle, use the right and left tilt adjusters.
Message for setup confirmation is displayed in a selected language.
Then, the menu for lamp power selection and configuration is displayed. It is automatically set as Standard. To change the setting, follow the step 2 .
2Use the 
or 
button to select the lamp power and press the 
button.
The lamp power, if selected, will be toggled without pressing the 
button. The display automatically disappears in a few seconds.
Notes
•When the projector is turned on the next time, the start menu does not appear upon startup. However, if [Reset all] is executed from the Default setting 2 menu p.42 , the start menu will be displayed the next time when the power is turned on.
•The language can also be set via the Display setting menu p.38 and Lamp power via the Default setting 2 menu p.42 .
•This owner’s manual assumes that English has been selected.
3Activate the connected device.
Turn on and start the connected device such as a computer.
4Press the INPUT button.
An image of the connected equipment is projected.
Each time you press the INPUT button, it switches to the input of the connected equipment that is outputting video signals.
•To stow the foot adjuster, hold up the projector while pressing the foot adjuster release button, then slowly lower the projector.
Note
•When [Auto keystone] is set to [On] in the Default setting 1 menu, the keystone distortion will automatically be corrected based on the projector placement angle. If you do not desire the automatic keystone correction, set [Auto keystone] to [Off].
6Adjusting the screen size and focus
1 Use the zooming lever to adjust the | Zooming lever | Focusing ring |
screen size. |
|
|
|
|
2 Use the focusing ring to adjust the focus.
7 Adjusting the volume with the 
buttons
The speaker volume can be adjusted when an audio signal is being input.
Operations
26 | 27 |
