Toshiba W-608 Cable Box Set-up(continued), •100, •CH (CABLE BOX), •POWER (CABLE BOX), •Number buttons (0 – 9), Buttons to control a remote- controllable cable box

Cable Box Set-up (continued)

7 Select “BRAND TYPE” using STOP, and enter a brand code of your cable box using number buttons. Refer to the table on the next page.

Example: For a TOSHIBA cable box, identified by number 36.

								Cable box display
PROGRAM				SET UP		PRESET
									VCR display
USE				no	c. Box	DSS
OUTPUT CH						03CH
COnTROL				Off
							on
BRAnD TYPE			no. 36
	TO SET BRAnD TYPE
		PUSH 0~9 KEYS
EnD : PROG								Cable channel number

Make sure that the channel display of your cable box has changed to

9.If not, try each brand code assigned to the brand of your cable box until the display changes to 9.

If it still holds;

• Relocate the cable box on the VCR.

• Use each of digits from 1 to 91.

8 Press PROG. three times to exit.

Notes

•If your cable channel does not change to 9 in step 7, the cable box will not be able to change channels in the timer recording. In this case, set “CONTROL” to “OFF” in step 6.

•The cable box control is not compatible with the DSS® satellite receiver control.

Buttons to control a remote- controllable cable box

Once you complete the set-up for a remote controllable cable box, your cable box can be controlled by the following buttons on the remote control of the VCR.

•POWER (CABLE BOX)

To turn the cable box on or off.

•CH (CABLE BOX)

To select cable channels in the upper or lower direction. (not applicable to some brands of cable box.)

•Number buttons (0 – 9)

To select desired channels to record.

•100

Some cable boxes require you to use this button as the enter button. Press this button after selecting the cable channel with number buttons.

34