TP-Link TD-W8968

TD-W8968 300Mbps Wireless N USB ADSL2+ Modem Router User Guide

3. Select Bridging option for the WAN service type on the screen (as shown Figure 4-7), and

click Next button to continue.

4. On the screen (as shown Figure 4-11) you will see the detailed settings you’ve made. Please

click the Apply/Save button to save these settings.

4.4.2.4 ATM-PPPoA

If your ISP provides a PPPoA connection and you need to use an ATM Interface, follow the steps

below to add a WAN service over a selected ATM interface:

1. Add a new ATM interface and select PPPoA option for DSL Link Type (see 4.4.1.1 ATM

Interface).

2. Click the Add button on the screen Figure 4-5 and the next configuration is similar to PPPoE,

(see section 4.4.2.1 ATM-EoA-PPPoE). The difference is that you don’t need to set the

PPPoE Service Name and Bridge PPPoE Frames Between WAN and Local Ports on the

screen of Figure 4-8.

4.4.2.5 ATM-IPoA

If your ISP provides an IPoA connection and you need to use an ATM Interface, follow the steps

below to add a WAN service over a selected ATM interface.

1. Add a new ATM interface and select IPoA option for DSL Link Type (see 4.4.1.1 ATM

Interface).

2. Click the Add button on the screen Figure 4-5 and the next configuration is similar to IPoE

(see section 4.4.2.2 ATM-EoA-IPoE). The difference is that you have to manually set the

Static IP Address on the screen of Figure 4-13, and the Static IP Address for DNS Server on

the screen of Figure 4-16.

) Note:

ETH and ATM service can not coexist. If the ATM Interface had configured, you cannot configure

any other WAN service over the ETH Interface until the ATM Interface is deleted.

4.4.2.6 ETH-PPPoE

If your ISP provides a PPPoE connection, click the Add button on the screen Figure 4-5 and the

following configuration is similar to PPPoE over ATM interface (see section 4.4.2.1

ATM-EoA-PPPoE).

4.4.2.7 ETH-IPoE

If your ISP provides an IPoE connection, click the Add button on the screen Figure 4-5 and the

next configuration is similar to IPoE over ATM interface (see section 4.4.2.2 ATM-EoA-IPoE).

4.4.2.8 ETH-Bridge

If you want to adopt the Bridge service, click the Add button on the screen Figure 4-5 and the next

configuration is similar to Bridge over ATM interface (see section 4.4.2.3 ATM-EoA-Bridg).