TP-Link TL-ER6020 Rear Panel

Gigabit Dual-WAN VPN Router

WAN The WAN port is designed to connect the Router to the int erface provided

by ISP via the RJ45 cable

LAN The LAN port is designed to co nnect the Router to the local PCs or

switches by the RJ45 cable

DMZ The DMZ port is designed to connect the Router t o the servers

Console

The Console port is designed to connect with the serial port of a computer

or terminal to check and monitor some simple system infor mation of the

Router

Use the button to restore the Router to the factory defaults. With the Router

powered on, use a pin to press and hold the Reset button (about 4~5 seconds1.

After the SYS LED goes out, release the Reset button. If the SYS LED is ashing

with a high frequency about two or three seconds, it means the Router is restored

successfully.

Rear Panel

■

The rear panel of TL-ER6020 is shown as the following figure.

Rear PanelFigure 1-2

Connect the female connector of the power cord here, and the male connector to

the AC power outlet. Please make sure the voltage of the power supply meets the

requirement of the input voltage.

The Router already comes with lightning protection mechanism. You can also ground

the Router through the PE (Protecting Earth1 cable of AC cord or with Ground Cable.

For detailed information, please refer to Chapter 3 Lightning Protection.

The Router provides one security slot.

Caution: Please use the provided power cord.

Introduction