¾ EN 300 328 V.1.4.1 | TP-Link TL-WN322G guide

Is here with confirmed to comply with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating to Electromagnetic Compatibility (89/336/EEC), Low-voltage Directive (73/23/EEC) and the Amendment Directive (93/68/EEC), the procedures given in European Council Directive 99/5/EC and 89/3360EEC.

The equipment was passed. The test was performed according to the following European standards:

¾EN 300 328 V.1.4.1 (2003)

¾EN 301 489-1 V.1.4.1 (2002) / EN 301 489-17 V.1.2.1 (2002)

¾EN 60950-1: 2001

European standards dictate maximum radiated transmit power of 100mW EIRP and frequency range 2.400-2.4835GHz; In France, the equipment must be restricted to the 2.4465-2.4835GHz frequency range and must be restricted to indoor use.

Image 4

TP-Link TL-WN322G manual ¾ EN 300 328 V.1.4.1, ¾ EN 301 489-1 V.1.4.1 2002 / EN 301 489-17 V.1.2.1 ¾ EN 60950-1

Contents

Page COPYRIGHT & TRADEMARKS All rights reserved FCC STATEMENT FCC RF Radiation Exposure StatementIMPORTANT NOTE FCC Radiation Exposure Statement CE Declaration of Conformity ¾ EN 300 328 V.1.4.1 ¾ EN 301 489-1 V.1.4.1 2002 / EN 301 489-17 V.1.2.1 ¾ EN 60950-1 Chapter TL-WN322G 54M Wireless USB Adapter User Guide Package Contentsy Drivers and Utility 1.1 Features LED IndicatorChapter 1 Introduction 1.2 LED Status Ad-hoc peer-to-peer Mode 1.4 Network ConfigurationInfrastructure Mode Figure 1-2 Infrastructure mode 2.2 Installing the Drivers Chapter 2 Installation Guide2.1 Before You Begin Figure 2-3 Install Shield-Setup Status Figure 2-2 Install Shield-Choose Destination Location¾ Wait a few moments until the files are copied to the computer Figure 2-4 Installation Complete 1. Click on Start Settings Control Panel Add or Remove Programs Chapter 3 Uninstall Guide3.1 Through Control Panel TL-WN322G Wireless Utility 3.2 Through Programs Figure 3-5 Confirm the Uninstalling process Figure 3-6 Uninstalling TL-WN322G Wireless Utility and the drivers Figure 3-7 Uninstalling process finished Chapter 4 Software Configuration 4.1 Station Mode Configuration4.1.1.1 General Connection Setting ¾ Current Network Information Figure 4-2 More setting ¾ You can click “Change” button to change general connection settings Figure 4-3 More setting-Click Change Figure 4-4 More setting-WEP 4.1.1.2 WEP Encryption 4.1.1.3 WPA/WPA2 Authentication with TKIP/AES Encryption ¾ Click on the WPA Encryption Setting button Figure 4-8 WPA setting ¾ Protocol Select TLS from the drop-down list 4.1.1.4 WPA-PSK Authentication 4.1.1.5 Profiles 4.1.1.6 Advanced Settings 4.2 Wireless network mode configuration Figure 4-15 Access point setting 5.1 Configuration of WEP Encryption Chapter 5 Examples for application Step 6 ： Step 3：ClickStep 5.2 Configuration of PSP Mode There is two parts of this setting：Part 1：Configuration of our TL-WN322G 54M Wireless USB Adapter Step One： Select “Access Point” from the drop down list Remark Step Six：Select address settings mode-Easy Step Nine： ”Proxy Server” select ”Do Not Use” Step Ten： Select ”Test Connection” Appendix A Glossary ¾ PEAP- Protected Extended Authentication Protocol ¾ RADIUS- Remote Authentication Dial In User Service¾ PSK- Pre-Shared Key ¾ TKIP- Temporal Key Integrity Protocol ¾ AES- Advanced Encryption Standard ¾ TLS- Transport Layer Security Appendix B Specifications Media AccessTransmit Power Safety& Emissions Appendix C Contact Information