Trane 32-5064-WEB01 manual The Problem Solver - Gas Furnaces, Downflow Filter, Downflow/Horizontal

Proper Maintenance – Gas Furnaces

Air filters may also be located outside of the furnace using a remote filter grille. The filter grille could be in a hallway, wall, or in the ceiling. Check with your dealer for the exact location of your filter and the method of changing the filters.

Downflow/Horizontal furnaces are factory supplied with 2 standard size permanent type air filters which may be located remote to the furnace or in the return air duct. Check with your dealer for the location of your filters.

	A downflow/horizontal furnace return air filter application, as
	shown, features two 14" x 20" x 1" filters in the 17-1/2" wide
	furnace cabinets; or two 16" x 20" x 1" filters in the 21" and
	24‑1/2" wide furnace cabinets.
	For regular dealer maintenance please refer to
	www.acca.org/industry/quality
Airflow
	Airflow
Downflow Filter	Downflow/Horizontal
	With Filter Kit

The Problem Solver – Gas Furnaces

Before you call for service, check the following:

Problem	Possible cause	Possible Remedy
No heating –	1. Thermostat set incorrectly	1. Adjust thermostat. See operating instructions.
Blower does not operate	2. Blown fuse or tripped circuit breaker	2. Replace or reset protective device or call for servicer
	3. Defective component	3. Most controls are automatic and will recycle. If your unit
	4. Burner does not ignite	still does not operate call for servicer.
	5. Main gas line turned off	4. Call servicer
	6. Blower door removed or ajar	5. Have gas company check
	7. Lockout	6. Close door securely to restore power to blower
		and gas valve
		7. Turn power on-off-on-off twice in 30 seconds
Insufficient heating or cooling	1. Dirty filters	1. Clean or replace
	2. Air not circulating freely	2. Check supply registers and return grills for blockage
	3. Blocked outdoor coil	3. Clear away leaves or other debris
No Heat – Vent motor is running	1. Restricted or plugged furnace	1. Remove drain clamps to condensate trap
	condensate drain	and drain pan outlet
		2. Flush or clean drain blockage
		3. Reinstall clamps
Unusual Noise		Call your local servicer

CARBON MONOXIDE POISONING HAZARD

DO not attempt to change the venting system. Failure to follow the installation and operation instructions for the venting system’s operation could result in carbon monoxide poisoning or death.

NOTE: Improperly sized vents can cause the formation of condensate, combustion gas leakage and spillage, and an inoperable furnace.

A furnace is not a household appliance. It is complex and requires professional maintenance and repair. Attempts at “do-it-yourself” repairs on an in-warranty unit may void the remainder of your warranty.

Other than performing the simple maintenance recommended in this manual, you should not attempt to make any adjustments to your furnace. Your dealer will be able to take care of any questions or problems you may have. A periodic inspection of your furnace should be made by a qualified service agency at the start of each heating season.

In the event that electrical, fuel, or mechanical failures occur, immediately turn the gas supply off at the manual gas valve located on the gas pipe leading to the furnace before turning off electrical power to the furnace. Contact a qualified service agency.

Keep your furnace looking like new for years.

Clean the enamel finish of your furnace with ordinary soap and water. For stubborn grease spots, use a household detergent. Lacquer thinner or other synthetic solvents may damage the finish.

8 32-5064-WEB01