Manuals / Trane / Household Appliance / Heat Pump

Trane GETB manual Start-upChecklist and Log, Heat, Cool

Models: GETB

1 32

Download 32 pages 56.41 Kb

Page 24

Image 24

Start-up Checklist

and Log

Installing Contractor: Use this form to thoroughly check-out the system and units before and during start- up. (This form need not be returned to the factory unless requested during technical service support).

Job Name:

Model Number:

Date:

Serial Number:

In order to minimize troubleshooting and costly system failures, complete the following checks and data entries before the system is put into full operation.

MODE

Entering fluid temperature

Leaving fluid temperature

Temperature differential

Return-air temperature DB/WB

Supply-air temperature DB/WB

Temperature differential

Water coil heat exchanger (Water Pressure IN)

Water coil heat exchanger (Water Pressure OUT)

Pressure Differential

COMPRESSOR

Amps

Volts

Discharge line temperature (after 10 minutes)

HEAT

PSIG

COOL

PSIG

24	WSHP-SVN08B-EN

Page 24

Image 24

Trane GETB manual Start-upChecklist and Log, Heat, Cool

Contents

Installation Owner Diagnostics Vertical StackWater-SourceHeat Pump Model GETB FebruaryResponsible Refrigerant Practices Contents Installation/Startup/CommissioningMaintenance Warranty InformationPre-installation Checklist Fiberglass WoolMicrobial Growth Jobsite InspectionGeneral Information Unit NameplateCompressor Nameplate Unit DescriptionDimensions/Weights/ Clearance WARNING Improper Unit LiftTable 1 Unit weights Figure 1 Mechanical clearancesDimensions Hinged Acoustical Door DimensionsReturn Air hinged Acoustical Door Installation WARNING Hazardous VoltageGeneral Installation Checks Low Voltage Wiring AC & DC RequirementsImproper Unit Lift InstallationUnit Placement variation in floor-to-floordimensionsLive Electrical Components Use Copper Conductors OnlyHazardous Voltage InstallationInstallation Drywall InstallationUnits utilizing Hinged Acoustic Door Assembly 5, mock-upof stud placementInstallation Chassis InstallationFigure 6 Door opening Figure 7 Air panel gasketInstallation Supply Grille installationCleaning and Flushing the Water Loop Figure 11 Install chassis centeredInstallation Using AntifreezeTable 3 Antifreeze requirements based on volume Minimum Temperature for Freeze ProtectionLow Voltage Wiring InstallationLow Voltage Wiring Six 6 Pin Connector/HarnessAir Flow Adjustment InstallationHazardous Voltage Blower Motor Speed RetrofitElectrical Requirements Table E1 Electrical PerformancePre-Start Checklist Pre-Start-upChecklistSequence of Operation Live Electrical ComponentsInitial Unit Start-up Start-upwith deluxe controls is included belowOperating Pressures Table OP-1 Operating PressuresOperating Pressure Table OP-1 Operating PressuresWater Volume Table 8 Water volumeStart-upChecklist and Log Operating PressuresStart-upChecklist and Log HEATCOOL Maintenance Hazardous VoltageHazardous Chemicals Preventive MaintenanceWarranty Information Warranty Information Standard WarrantyExtended Warranty Troubleshooting Hazardous Service ProceduresGeneral Operation Operation with a Conventional ThermostatTroubleshooting Checklist Unit Wiring Retrofit Diagram 208/230V-50/60 Hz-1PHUnit Wiring Deluxe Diagram 208V-50/60 Hz-1PHUnit Wiring ZN510 Diagram 230V-50/60 Hz-1PHTrane A business of American Standard Companies