![](/images/new-backgrounds/1172835/17283519x1.webp)
2.2.2Installing the Managment Modules
CAUTION: Wear a grounding device and observe electrostatic discharge precau- tions when installing the Management Module(s) in the
Install one (1) Master Management Module
If several PointSystem™chassis are to be connected in a cascade fashion (see sec- tion 4.3 Cascade Option):
•Install one (1) Master Management Module
•Install one (1) Master Management Module
NOTE: Though the Management Module(s) can be installed in any PointSystem™ chassis slot, use of the
To install a Management Module:
1a. CPSMM-200 Dual-Slot Master Management Module:
Remove two (2) Management Module protective plates from two (2) installation slots at the
1b.
Remove one (1) Management Module protective plate from one (1) installation slot at the
2.Align the Management Module with the PointSystem™ chassis installation slot so that the panel fastener screw is to the left of the Management Module.
|
|
|
|
|
|
| Input Power: |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| 1.6A max. (60W max) |
|
|
|
|
|
|
| 50/60 Hz |
|
| RESET |
|
|
| ||
PWR | LNK |
|
|
|
| ||
TX | RX |
|
|
|
|
| |
|
| TERM | INIT | 12C |
| MGMT MASTER | |
| INPORT | OUTPORT | MCCM10 |
Panel Fastener Screw
3.Carefully slide the Management Module into the installation slot, aligning the Management Module with the installation guides.
NOTE: Ensure that Management Module is firmly seated against backplane.
4.Rotate the attached panel fastener screw clockwise to secure the Management
Module to the PointSystem™ chassis.
slide-in-modules
Tech Support: | 10 |