Installing Thicknet 10BASE-5 Cable
The LANMaster T8 provides a female AUI connector at the back for network connection to
CONNECTING TO 10BASE-5 USING AUI DROP CABLE
To connect to
1. Locate or build IEEE 802.3 compliant AUI drop cable.
2. Connect AUI drop cable male connector to female AUI (DTE) connector on LANMaster T8.
3. Connect AUI drop cable female connector to the AUI port on a
4. Verify that
segment is terminated at both ends using
CONNECTING TO NETWORK USING TRANSCEIVER
NOTE: Refer to transceiver documentation for detailed specifications.
To connect to network using transceiver:
1.Locate IEEE 802.3 compliant transceiver with male AUI connector and with required network media connector.
2.Connect transceiver male AUI connector to the female AUI connector on LANMaster T8.
3.Referring to transceiver documentation, connect transceiver network media connector to the network media.
TO FIBER, COAX,
OR TWISTED PAIR
13 | LANMaster™ T8 |
Installing LANMaster T8 at Site
NOTE: Mounting brackets, screws, and rubber feet are provided.
To install the LANMaster T8 on table or other flat surface:
1.Carefully turn LANMaster T8 to side.
2.Install four (4) rubber feet (included with packing material):
•Separate rubber feet.
•Remove protective paper from
adhesive surface of rubber foot.
• Position and secure each rubber foot as shown.
3. Return LANMaster T8 to upright position.
To install the LANMaster T8 mounting bracket under shelf or on wall:
| 2 | 1. Using mounting bracket as a guide, with |
| |
|
| pencil or other marking device, mark screw |
| |
|
| installation locations on wall or under shelf. |
| |
1 |
| 2. Using Phillips screwdriver, install two (2) |
| |
|
| screws (included with packing material) at |
| |
| 2 | installation locations marked on wall or under |
| |
|
| shelf. |
|
|
3. | Using Phillips |
|
| |
| screwdriver, install two |
|
| |
| (2) screws (included |
|
| |
| with packing material) |
|
| |
| through mounting |
|
| |
| bracket securely into | 3 |
| |
| LANMaster T8 chassis. |
|
| |
4. | Carefully install |
|
| |
|
| mounting |
|
|
|
| bracket, with |
|
|
|
| attached |
|
|
|
| LANMaster T8 chassis, to installed mounting screws, |
| |
|
| aligning mounting bracket so that mounting screws |
| |
|
| are secured at narrow end of bracket mounting |
| |
| 6 |