Installing Network Cable
10BASE-T Requirements
STRAIGHT-THROUGH/CROSSOVER CABLE/CONNECTOR
NOTE: The
The “X” port provided on the LANMaster T8 changes a physical straight through cable configuration to a logical crossover cable configuration for hub to hub connections.
Therefore, ensure that all
1 2 3 4 5 6 7 8
Installing Thinnet 10BASE-2 Cable
The LANMaster T8 has a female BNC MDI connector installed at the back for connection to
To connect to
1.Locate or build IEEE 802.3 compliant
2.Install the mating
3.Install
4.Install
OR, if the LANMaster T8 is the last network device in the daisy chain, install a
5.Verify that the
Straight Through Cable
at
8 |
1
50 ohm terminator
earth ground
In a coax thinnet installation, the first and last device in the daisy- chain must be terminated with a 50 ohm terminator. Additionally, the
Hub . . . . . . . . . . . . . . . .PC, transceiver, NIC, printer
ground” at one end.
1 . . . . . . . . . . . . . . . . . . .1 2 . . . . . . . . . . . . . . . . . .2 3 . . . . . . . . . . . . . . . . . .3 6 . . . . . . . . . . . . . . . . . . .6
The two active pairs in a
50 ohm terminator
7 | LANMaster™ T8 | 12 |