Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary. In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code. To change the digital security code:

1. De- register the Handset (see page 28).

2. Re- register each handset by following the steps on page 17.

Installing the Beltclip

To attach the beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks.

To remove the beltclip

Pull either side of the beltclip to release the tabs from the holes.

Optional Headset Installation

Your phone may be used with an optional headset. To use this feature, insert the headset plug into the headset jack. Your phone is ready for hands- free conversations. (Headset may be purchased visiting the web site. See page 78.)

[18]

￿If you have more than one handset, de- register all the handsets you have.

￿If you de-register another handset, perform "Replacing the Base Setting" for the handset after you de-register it (see page 28).

GETTING STARTED

Page 19
Image 19
Uniden WDECT 2345+1 owner manual Changing the Digital Security Code, Installing the Beltclip, Optional Headset Installation