Traveler AS-TV8 manual D. In/Out Jacks see page, E. Speaker Out see page

D. In/Out Jacks (see page 7)

1.The system contains Line In, Line Out, and Mic in jacks for connecting external audio devices.

2.Line In (E1): Pg.7 RCA jacks to connect external audio sources, such as CD/ MP3 players or iPods. The volume of the Line In is controlled solely by the Master (D1).

3.Line Out (E2): RCA jacks to send the signal to other audio devices, such as recorders, mixers, or power amps.

4.Mic In (E3): XLR or 1/4” (6.3mm) phone jack for wired microphones. Volume of this input is controlled by Mic In (D4) and the Master (D1).

E. Speaker Out: (see page 7)

1. Used to connect to an external unpowered speaker (8Ω Min.)

F. Digital Echo System (see page 8)

1.Turn the power switch (H1-1)Pg.8 clockwise to turn on the echo system. Then use this control to adjust the level of echo in the mix .

2.Adjust the repeat button (H1-2)to select the number of repeats desired. Adjust the delay button to select the delay time.

3.Mic input jacks (H1-6and H1-7)are provided for connecting wired Mics. Mic volume is controlled by H1-4and H1-5plus the Master (D-1).

G. Audio Link Transmitter (see page 8)

This module transmits the entire audio mix from one Traveler to another Traveler equiped with a wireless Mic/Audio Link Receiver.

1.Turn the power switch (H2-7)clockwise to turn on the transmitter.

2.The LCD display (H2-1)will show “On” and the channel in use when the unit was last turned off.

3.To select a different channel, press the set button (H2-5)and the channel will flash in the LCD display. Press the up or down button (H2-6)to select the transmit channel, and then press the set button again to enter the setting. The LCD will then automatically display the selected channel. To display the frequency of the selected channel press and hold either the up or down button.

4.Turn the volume control (H2-7)to adjust the audio transmit level. Use this control in conjunction with the volume controls on the receiving Traveler.

11