In the DiSEqC line, DiSEqC mode can be changed to OFF/ON. While DiSEqC is switched to OFF, REPEAT automatically changes to “0”, no DiSEqC signals are gen- erated and the installation menu is as in installation page description. The user can not reach REPEAT line in this mode.
If any DiSEqC device will be used (e.g. DiSEqC 1.0 or 2.0 switch, multiswitch or LNB), DiSEqC mode must be selected as ON to communicate with these devices. In this mode, DiSEqC signals are sent with the analog 13/18V, 22kHz and toneburst signals.
The installation menu changes like this in DiSEqC ON mode.
LNB Numbers can be increased up to 16 while DiSEqC is ON. Satellite Position is combination of Position and Option as below.
DiSEqC device address is chosen as 00H to support all devices.
In REPEAT line, repeat number of DiSEqC signals can be selected. This number corresponds to the number of cascaded DiSEqC accessories in your sat system. For example if there is only one DiSEqC switch (or multiswitch), repeat number may be
0.If there is a DiSEqC switch (or multiswitch) and a DiSEqC LNB, repeat number must be 1.
In VIDEO MUTE line Video Mute function can be enabled or disabled. When VIDEO MUTE is OFF, there will be no blue background even if there is no video signal or video signal is too bad. This mode is recommended during dish installation. When VIDEO MUTE is ON, there will be blue background if there is no video signal or video signal is too bad. This mode is recommended after installation procedure has finished.
- 13 -
