IMPORTANT SAFETY REQUIREMENTS
Important
This cooker must be installed in accordance with the IEE Wiring Regulations (Current Edition). Detailed recommendations are contained in the following British Standards Codes Of Practice:
B.S. 6172/ B.S. 5440, Par.2 and B.S. 6891 Current Editions.
LOCATION
The cooker has been registered as a “Class X” |
| |
appliance according to Fire Risk Regulations. |
| |
Any adjacent cabinets or walls must not exceed |
| |
the cooker’s height. |
| |
The cooker may be located in a kitchen, a |
| |
kitchen/diner or bed sitting room, but not in a | mm | |
bathroom, shower room or garage. | ||
660 | ||
| ||
The minimum distance combustible material can |
| |
be fitted above the cooker in line with the edges |
| |
of the cooker is 660mm (see fig.) |
| |
|
|
C
1 G
2
3
4
5678
150 mm | 610 mm |
|
Levelling
Fix the support with two legs with the washer and nuts, delivered with the cooker, see the figure.
•Unscrew the legs as far as possible (approx. 16mm from fully screwed in).
•Place the plinth (pos.3) so that the springs (pos.2) reach the threaded area of the legs and the clamp of the plinth (pos.4) is in front of the holes (pos.5) on the under side of the structure.
•Push the plinth towards the appliance with both hands until the springs fasten on the legs and the clamps go into the corresponding holes.
•Adjust the legs as necessary.
4
5
3
2
1
18
