Levelling
The appliance is provided with adjustable small feet placed in the back and front corners of the base.
By adjusting the small feet it is possible to change the height of the appliance so as to ensure a better levelling with other surfaces and a uniform distribution of the liquids contained in pans or pots.
GAS CONNECTIONS
Gas connection must be carried out according to the rules in force.
Your cooker is delivered adjusted for the kind of gas stated on the rating plate.
If the appliance is converted to natural gas and the pressure for natural gas is 20mbar. The following methods of connection to the gas supply must be used:
Left Hand Connection (from front)
Ensure that the rubber hose and power cord are not in contact with any part of the hatched area shown in the diagram and that the loop of the hose when connected is not in contact with the floor when the appliance is in position.
Right Hand Connection (from front)
Ensure that the rubber hose and power cord are not in contact with any part of the hatched area shown in the diagram. It will be necessary to fit the maximum length hose when using this
method.
Rigid Connection
Where it is not possible to make the connection using a rubber hose, a rigid pipe work connection must be used.
Recommendations when using an appliance flexible connector are as follows:
-For NATURAL the gas installation pipes to the termination point shall comply with:
Specification for installation of
Flexible hoses, end fittings and sockets for gas burning appliances – BS 669;
22
connection 
of flexible
hose
power 
cord
connection of flexible hose
power
cord
