Electrical connections
Any electrical work required to install this cooker should be carried out by a qualified electrician or competent person, in accordance with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not be observed.
This cooker is designed to be connected to a
Before switching on, make sure the electricity supply voltage is the same as that indicated on the cooker rating plate. The rating plate is located on the oven frame.
The cooker is supplied with a
Green and Yellow | - Earth |
Blue | - Neutral |
Brown | - Live |
-Connect the green and yellow (earth) wire to the terminal in the plug, which is marked with
the letter 'E' or the earth symbol 
or coloured green and yellow.
-Connect the blue (neutral) wire to the terminal in the plug, which is marked with the letter 'N' or coloured black.
-Connect the brown (live) wire to the terminal in the plug, which is marked with the letter 'L' or coloured red.
NOTE: The earth wire should be about 2 cm longer than the live and neutral wires.
Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
20
A cut off plug inserted into a
Before connecting check that:
•The plug used for connection is easily accessible when the appliance is installed.
Permanent Connection
In the case of a permanent connection, it is necessary that you install a double pole switch between the cooker and the electricity supply (mains), with a minimum gap of 3mm, between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations.
The switch must not break the yellow and green earth cable at any point.
Ensure that the cooker supply cord does not come into contact with surfaces with temperatures higher than 50 deg. C.
