Manuals
/
Tripp Lite
/
Computer Equipment
/
Power Supply
Tripp Lite
200703028 1111 W. 35th Street, Chicago, IL 60609 USA, USA 773.869.1212 International
Models:
200703028
93-2486
1
15
15
Download
15 pages
14.58 Kb
8
9
10
11
12
13
14
15
<
>
Troubleshooting
Install
Error codes
Battery Replacement
“REPLACE BATT” LED This red light will illuminate constantly and the UPS alarm will beep every 2 seconds if your UPS’s microprocessor detects a battery fault or if your UPS fails the automatic self-test after you turn your UPS ON and the UPS battery is less than fully charged. Let the UPS system charge for at least 12 hours and perform a self test using the “ON/TEST Button” as described on page 7. If the light continues to stay on, contact Tripp Lite for service
Battery Warnings
Connect a user-supplied power cord to the UPS input receptacle
Storage and Service
“ON/TEST” Button This switch controls four separate UPS functions
Page 15
Image 15
1111 W. 35th Street, Chicago, IL 60609 USA
773.869.1234 (USA) • 773.869.1212 (International)
www.tripplite.com
200703028
93-2486_EN
Page 14
Page 15
Image 15
Page 14
Contents
Battery Replacement
Important Safety Instructions
Installation
Troubleshooting
UPS Connection Warnings
Battery Warnings
SAVE THESE INSTRUCTIONS
UPS Location Warnings
Installation
4-Post Mounting
Mounting Rack
1 Connect a user-supplied power cord to the UPS input receptacle
Installation continued
InstallationImporant continuedSafety Instructions
3 Turn the UPS ON
1 Phone/Network Line Suppression
Installation continued
4 External Battery Connection
2 USB and RS-232 Serial Communications
3 EPO Port Connection
Basic Operation
“ON/TEST” Button This switch controls four separate UPS functions
Front Panel Indicator Lights continued
Basic Operation continued
Basic Operation continued
“REPLACE BATT” LED This red light will illuminate constantly and the UPS alarm will beep every 2 seconds if your UPS’s microprocessor detects a battery fault or if your UPS fails the automatic self-test after you turn your UPS ON and the UPS battery is less than fully charged. Let the UPS system charge for at least 12 hours and perform a self test using the “ON/TEST Button” as described on page 7. If the light continues to stay on, contact Tripp Lite for service
Communications
Power Over Ethernet applications
Basic Operation continued
Rear Panel continued
Troubleshooting
or low for the UPS to operate in BYPASS
Troubleshooting continued
This indicates that utility power is too high
adequate space for air to circulate near
Battery Replacement
Procedure
Storage and Service
Service
Storage
1111 W. 35th Street, Chicago, IL 60609 USA
773.869.1234 USA 773.869.1212 International
200703028 93-2486EN