Tripp Lite 93-2486, 200703028 owner manual Installation continued

Installation (continued)

2-Post (Telecom) Mounting

If you mount 2U UPS models in 2-post racks, they require the addition of a Tripp Lite 2-Post Rackmount Installation Kit (model: 2POSTRMKITWM, sold separately). See Installation Kit owner’s manual for installation procedure for 2U UPS models.

Mounting (Tower)

Your UPS can be mounted in an upright tower position with optional base stands sold separately by Tripp Lite (Model # 2-9USTAND). When mounting the UPS on adjustable base stands, make sure that the control panel is toward the top. The control panel may be rotated to make it easier to read. Insert a small screwdriver or similar tool in the slots on either side of the panel, pop it out, rotate it, and pop it back into place as shown.

WARNING!

All UPS systems are extremely heavy. Use caution when lifting and mounting. User must properly stabilize the UPS when lifting and mounting.

Connection and Start-Up

1Connect a user-supplied power cord to the UPS input receptacle.

The power cord should have a plug appropriate for your local site's utility outlets. Plug the cord directly into a properly grounded, 3-wire, AC outlet that does not share a circuit with a heavy electrical load (air conditioner, refrigerator, etc.). The outlet must have an amp rating equal to or greater than the input breaker rating of the UPS.

Note: Once your UPS is plugged in, the fan and all Indicator Lights will turn ON. The LINE and LOAD ACTIVE METER LEDs will illuminate and the UPS will beep to indicate normal operation. However, power is not supplied to the AC outlets until the UPS is turned on.

2Using the included power cords, connect your equipment to the AC outlets of the UPS System.

Connect the female plug to your equipment's AC input. Connect the male plug to any UPS AC outlet 2a . Repeat with additional cords to connect all your equipment 2b .

Note: Additional interconnection cords C13 to C14 and C19 to C20) are available from Tripp Lite. For more information, call 773-869-1234.

Caution: Your UPS is designed to support computer equipment only. You will overload the UPS if you connect devices with high power demands such as household appliances or laser printers to UPS AC outlets.

1Your model may differ.

INPUT	ACC. SLOT
BREAKER

	LOAD 1	LOAD 2	OUTP
		RS-232	USB
			CAUTION
			Risk of electric sh
			See top of unit fo
IN	OUT	EPO	cautionary markin

PHONE / DATA PROTECTION

2a Your model may differ.

ACC. SLOT

			OUTPUT
	LOAD 1	LOAD 2
		RS-232	USB
			CAUTION	WARNING
				CONNECT 48 VDC
			Risk of electric shock	BATTERY SYSTEMS ONLY
			See top of unit for	CONNECTING OTHER
IN	OUT	EPO	cautionary markings	SYSTEMS WILL VOID
				WARRANTY

PHONE / DATA PROTECTION

2b Your model may differ.

4