Tripp Lite 200703028, 93-2486 InstallationImporant continuedSafety Instructions, Turn the UPS ON

InstallationImporant (continued)Safety Instructions

Connection and Start-Up (continued)

3Turn the UPS ON:

•Press the ON/TEST Switch and hold it for several seconds until you hear a beep

•Release the ON/TEST Switch. The ON LINE LED will illuminate, and your UPS will begin providing power to its AC outlets

Note: After initial installation of the UPS or after prolonged storage, the internal batteries must charge for 2- 4 hours before the UPS can support connected equipment during a power failure.

3

Optional Connections

Your UPS will function properly without these connections.

1Phone/Network Line Suppression

Your UPS has jacks which protect against surges on a telephone line or telephone/ network data line.* Using appropriate telephone or network cords connect your wall jack to the UPS jack marked “IN.” Connect your equipment to the UPS jack marked “OUT.” Make sure the equipment you connect to the UPS's jacks is also protected against surges on the AC line.

* Not compatible with PoE (Power Over Ethernet) applications.

ACC. SLOT

	LOAD 1	LOAD 2	O
		RS-232	USB
			CAUTION
			Risk of elec
			See top of u
IN	OUT	EPO	cautionary m

PHONE / DATA PROTECTION

1Your model may differ.

5