Manuals / Tripp Lite / Computer Equipment / Power Supply

Tripp Lite 200703028, 93-2486 owner manual Procedure, Battery Replacement

Models: 200703028 93-2486

1 15

Page 13

Battery Replacement

Under normal conditions, the original batteries in your UPS will last many years. See "Important Safety Instructions" before replacing batteries. The batteries are designed for hot- swap replacement (i.e. leaving the UPS in ON mode), but some qualified service personnel may wish to put the UPS in the OFF mode and disconnect equipment before proceeding.

Procedure

1Remove Front Panel

2Disconnect Batteries

3Remove/Dispose of Batteries

4Add Batteries

5Connect Batteries

Attach connectors: black- to-black and red-to-red.

6Replace Front Panel

1
	6

2
	5

3 4

Page 13

Image 13

Tripp Lite 200703028, 93-2486 owner manual Procedure, Battery Replacement

Contents

Installation Important Safety InstructionsTroubleshooting Battery ReplacementSAVE THESE INSTRUCTIONS Battery WarningsUPS Location Warnings UPS Connection Warnings4-Post Mounting InstallationMounting Rack 1 Connect a user-supplied power cord to the UPS input receptacle Installation continued3 Turn the UPS ON InstallationImporant continuedSafety Instructions1 Phone/Network Line Suppression 2 USB and RS-232 Serial Communications 4 External Battery Connection3 EPO Port Connection Installation continuedBasic Operation “ON/TEST” Button This switch controls four separate UPS functionsFront Panel Indicator Lights continued Basic Operation continuedBasic Operation continued “REPLACE BATT” LED This red light will illuminate constantly and the UPS alarm will beep every 2 seconds if your UPS’s microprocessor detects a battery fault or if your UPS fails the automatic self-test after you turn your UPS ON and the UPS battery is less than fully charged. Let the UPS system charge for at least 12 hours and perform a self test using the “ON/TEST Button” as described on page 7. If the light continues to stay on, contact Tripp Lite for serviceBasic Operation continued Power Over Ethernet applicationsRear Panel continued CommunicationsTroubleshooting This indicates that utility power is too high Troubleshooting continuedadequate space for air to circulate near or low for the UPS to operate in BYPASSBattery Replacement ProcedureService Storage and ServiceStorage 773.869.1234 USA 773.869.1212 International 1111 W. 35th Street, Chicago, IL 60609 USA200703028 93-2486EN