Troubleshooting
The UPS’s control panel lights will turn on in the sequences below to signal that the UPS is having operational difficulties.
Lights (On/Flashing) and Condition | Solution |
On: REPLACE BATT | Let the UPS system charge for at least 12 hours |
Condition: Replace Battery | and perform a self test using the "ON/Test |
| Switch" as described on page 6. If the light |
| continues to stay on, contact Tripp Lite for service. |
|
|
On: BATT LOW, ON BATT | Prepare for imminent UPS shutdown. |
Condition: Battery Low |
|
|
|
On: BYPASS, LINE, LOAD, OVERLOAD | Reduce the load the UPS supports. |
Condition: On Bypass due to Overload |
|
|
|
Flashing: OVERLOAD | Remove the cause of the short circuit |
Condition: Short Circuit | from the UPS output. |
|
|
On: FAULT | Check the utility line for wiring problems such as |
Condition: Wiring Fault | reversed line and neutral or a missing ground. |
|
|
On: FAULT, 100% | Restart the UPS. If the problem persists, |
Condition: Battery Voltage too High | contact Tripp Lite for repairs. |
|
|
On: FAULT, BYPASS, LINE, 50% | Restart the UPS. If the problem persists, |
Condition: On Bypass due to | contact Tripp Lite for repairs. |
High Output Voltage |
|
|
|
On: FAULT, BYPASS, LINE | Restart the UPS. If the problem persists, |
Flashing: 50% | contact Tripp Lite for repairs. |
Condition: On Bypass due to |
|
Low Output Voltage |
|
On: FAULT, BYPASS, LINE, 25%
Condition: On Bypass due to High Bus Voltage
Restart the UPS. If the problem persists, contact Tripp Lite for repairs.
On: FAULT, BYPASS, LINE
Flashing: 25%
Condition: On Bypass due to Low Bus Voltage
Restart the UPS. If the problem persists, contact Tripp Lite for repairs.
On: BYPASS, LINE | Check the UPS to be sure that there is |
Flashing: FAULT | adequate space for air to circulate near |
Condition: On Bypass due to High | the vents and that the fan is working |
Internal Temperature | properly. Restart the UPS. |
|
|
Flashing: LINE | This indicates that utility power is too high or low |
Condition: Input Abnormal | for the UPS to operate in BYPASS mode, so if an |
| inverter failure occurs, the UPS will deliver no output. |
On: FAULT, 50%
Flashing: LINE
Condition: No Output due to High Output Voltage and Abnormal Input
Restart the UPS. If the problem persists, contact Tripp Lite for repairs.
On: FAULT
Flashing: LINE, 50%
Condition: No Output due to Low Output Voltage and Abnormal Input
Restart the UPS. If the problem persists, contact Tripp Lite for repairs.
10
