RS-232 Serial Control
5Once these settings are updated, the Terminal Emulation Software will recognize the switch, allowing you to enter commands to control it with. The following table lists the available commands.
Command | Action |
|
|
sw[x] [n] | Switches the source being displayed on the selected |
| output. [x] is the output (1, 2, 3, or 4) and [n] is the |
| desired source (A, B, C, or D). For example, a command |
| of sw1 2 would display source 2 on output 1. |
|
|
PWD | Turns power to the switch on/off. |
|
|
STE | Displays the current output state, showing which source |
| is being displayed on each output. |
|
|
8
8/5/2013 12:26:38 PM |
