Tripp Lite DWT1323S owner manual 2b. Mount on Solid Brick and Concrete Block

2b. Mount on Solid Brick and Concrete Block

1

Mark the exact location of mounting holes

2

Concrete Anchor

Drill pilot holes

Anchor Bolt

5mm-8mm

Screw the wall mount onto the wall

Tighten the screw spacing 5mm-8mm to wall plate.

WARNING

•When installing wall mounts on cinder block, verify the actual concrete thickness is at least 1-3/8” (35mm) for using the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1” (25mm) minimum from the side of the block. It is suggested an electric drill on a slow setting be used to drill the hole instead of a hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

•Installers must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.

5

13-09-229-93-32A5-EN.indd 5 10/31/2013 9:59:06 AM