Tripp Lite EMS Series owner manual Mounting, Vehicular and Non-Vehicular Horizontal Mount

Mounting

WARNING! Mount your Inverter/Charger BEFORE DC battery and AC power connection. Failure to follow these instructions may lead to personal injury and/or damage to the Inverter/Charger and connected systems.

Tripp Lite manufactures a variety of different Inverter/Chargers with a variety of different mounting options for use in vehicular or non-vehicular applications. Tripp Lite recommends permanent mounting of your Inverter/Charger in any of the configurations illustrated below. User must supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the Inverter/Charger. Contact Tripp Lite if you require further assistance in mounting your Inverter/Charger.

Vehicular and Non-Vehicular Horizontal Mount

(All Models except EMS1250UL)

AUsing the measurements from the diagram, install two user- supplied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly raised. B Slide the Inverter/Charger forward over the fasteners to engage the mounting feet molded on the front of the Inverter/Charger cabinet. C Install and tight- en two user-supplied ¼" (6 mm) fasteners into the mounting feet molded on the rear of the Inverter/Charger cabinet. The rear feet extend beyond the unit’s cabinet to provide for adequate ventilation space behind the cooling fan(s); they should not be

removed.C

"

" B

▼ "

A "

Vehicular and Non-Vehicular Horizontal Mount

(EMS1250UL models only)

AUsing the measurements from the diagram, install two user-sup- plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly raised. B Slide the Inverter/Charger back over the fasteners to engage the mounting slots molded on the bottom of the Inverter/Charger cabinet. C Install and tighten two user-sup- plied ¼" (6 mm) fasteners into the mounting feet molded on the front of the Inverter/Charger cabinet.

C

A

		4.5 in.
	B	(11.4 cm)
6.75 in.		▼

(17.1 cm)

	6.75 in.
	(17.1 cm)
7.87 in.
(20 cm)

Note: EMS model cabinets may have different front panel features, but all have identical mounting.

8E