Troubleshooting
PROBLEM
Your circuit breaker trips.
Your Isobar is overloaded.
The green "Protection Present" and/or "Line OK" LED(s) do not light.
Your equipment is not fully protected against surges or there is a wiring fault in your wall outlet.
The red "Fault" LED lights when you first plug in your Isobar.
There is a wiring fault in your wall outlet. (Phases are reversed, ground is missing, etc.)
The red "Fault" LED lights after continued use of your Isobar.
Your Isobar may have been damaged by a surge.
Equipment plugged into the Isobar exhibits audio static or video "snow".
Some equipment may be generating electri- cal interference.
SOLUTION
Unplug some equipment. Wait one minute while your Isobar cools, then push the circuit breaker button back in.
Make sure that power is available at the wall outlet, the power switch is on and lit, and the Isobar is completely plugged in.
Have a qualified electrician fix the fault immediately. NOTE: A loose wall outlet may cause the "FAULT" LED to light. Your Isobar will identify most wiring faults, but may not identify every possible type of fault.
Have a qualified electrician examine your outlet to determine if a fault has developed. If no fault exists, contact Tripp Lite for ser- vice.
Plug your equipment into outlets not directly across from each other and plug equipment with heavy power draws (such as printers) into outlets away from monitors and AV equipment.
3
