Tripp Lite RV1012ULHW Input, Battery, Leds Alarms & Switches, Surge / Noise Suppression, Physical

Peak output	2000
capacity (watts)
INPUT
Input connection	DC INPUT: Set of 2 DC bolt-down terminals. AC INPUT: hardwire
type
Input cord length	DC INPUT: User supplies cabling. 4 gauge or larger (see manual). AC INPUT: hardwire
Recommended	DC INPUT: Requires 12V DC input source capable of delivering 95A for the required duration (when used at full
Electrical Service	continuous capacity - DC requirements increase during Over-Power and Double-Boost operation). For automotive
	applications, professional hardwire
Maximum input	DC INPUT: Full continuous load - 95A at 12V DC. AC INPUT: 20 amps at 120V AC with full inverter and charger load (12A
amps / watts	max charger-only / combined input load to support charger and AC output is automatically controllable to 66%-33%-0%
	based on AC output lo
BATTERY

Expandable battery runtime

DC system voltage

Battery recharge rate

Runtime is expandable with any number of user supplied wet or gel type batteries

12V

14A / 55A (selectable)

LEDS ALARMS & SWITCHES

Front panel LEDs

Switches

Set of 6 LEDs offer continuous status information on load percentage (6 levels reported) and battery charge level (7 levels reported). See manual for sequences.

3-position on/off/remote switch enables simple on/off power control plus auto/remote setting that enables distant on/off control of the inverter system when used in conjunction with APSRM4 accessory (sold separately) in inverter mode. In AC uninterruptible power mode, auto/remote setting enables automatic transfer from line power to battery power, maintaining continuous AC power to connected loads.

SURGE / NOISE SUPPRESSION

AC surge	450 joules AC surge suppression included
suppression
PHYSICAL
Shipping weight	31.2
(lbs)
Shipping weight	15.1
(kg)
Shipping	13.5 x 15 x 21.5
Dimensions
(HWD/in)

Shipping Dimensions (HWD/cm)

34.3 x 38.1 x 54.6

Unit weight (lbs)	28.6
Unit weight (kg)	13
Unit Dimensions	7.25 x 8.5 x 16.25
(HWD/in)
Unit Dimensions	43.8 x 21.6 x 41.3
(HWD/cm)
Material of	Polycarbonate
construction
Form factors	Mounting slots enable permanent placement of inverter on any horizontal surface (see manual for additional mounting
supported	information)
Cooling method	Multi-speed fan
Style	Heavy-duty with built-in battery charger
ENVIRONMENTAL
Relative Humidity	0-95% non-condensing