3 – Installation (continued)
3-5 Installation Within Row
Note: Follow the instructions in this section only if the SRCABLELADDER accessory will be installed within a row of enclosures. If the SRCABLELADDER accessory will be installed across an aisle, follow the instructions in Section
1Insert four assembly brackets A in the open ends of the ladder, hooked end first. When the ladder is oriented so that the ladder’s rungs are above the ladder’s side rails, the hooked ends of the brackets should point down, as shown in the drawing.
2Align the pin holes in the ladder sections with the pin holes in the assembly brackets and insert clevis pins B into the pin holes (4 total). This step may be omitted to provide additional installation flexibility, but installing the pins will make the
SRCABLELADDER accessory more stable. Warning: If you choose not to install the clevis pins, make sure at least 25% of the length of each assembly bracket is inside the ladder.
3After inserting the clevis pins, insert a cotter pin C through the hole at the end of each clevis pin. (The straight section of the cotter pin goes through the hole.)
4Using an assistant, lift the SRCABLELADDER accessory (rungs upward) and align the holes at the ends of the assembly brackets
D with the corresponding holes E in the SRCABLETRAY accessories installed at the top of each enclosure. Note: There are two levels of holes. Use the holes that match your application best.
| A |
1 |
|
| B |
2 | B |
| |
| C |
3 |
E |
D |
4 |
5Align the pin holes and insert clevis pins F into each of the pin holes (4 total).
F |
5 |
6
