Tripp Lite SREXTENDER owner manual Frame Assembly

Preparation (continued)

Parts List (If any parts are missing, contact Tripp Lite.)

Note: The hinge swivels H and 12 hinge swivel screws L are pre-installed in the vertical sections A through D .

	Lower Left Vertical Section (1)		1U Blanking Panels (3)
A		G
	Lower Right Vertical Section (1)		Hinge Swivels (6 - all pre-installed)
B		H
	Upper Left Vertical Section (1)		Hinges (4)
C		I
	Upper Right Vertical Section (1)		Cable Manager Brackets (2)
D		J
	Top Section (1)		M6 x 12 mm Flat-Head Screws (8)
E		K
	Bottom Section (1)		M6 x 12 mm Pan-Head Screws
F		L

and Washers (14 total - 12 pre-installed)

MM5 x 10 mm Pan-Head Screws and Washers (40)

NGrounding Cable (1)

OM5 x 20 mm Pan-Head Screws and Washers (4)

PM4 x 8 mm Pan-Head Screws and Washers (8)

A B C D E H K N

F	I	O
		L

G

J M P

1 – Frame Assembly

Note: For 25U enclosures, you will use only the lower vertical sections For 48U and 42U enclosures, you will use all four vertical sections.

1-1(For 25U enclosures, skip this step.) Slide the lower left vertical

section A inside the upper left vertical section C as shown. Repeat for the lower right vertical section B and the upper right vertical section D . The vertical sections are not interchangeable, so refer to the diagram to confirm that you’re assembling the correct sections.

Aand B . You will not use the upper vertical sections C and D .

48/42U

C

D

A

B

1-1

2