Troy-Bilt 030245 manual Install Wheel Kit, Unpack the Generator, Section Assembly

Section Assembly

3

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-888-611-6708. If calling for assistance, please have the model, revision, and serial number from the data tag available. See “Know Your Generator” for data tag location.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install these components:

•13mm wrench

•Socket wrench with a 13mm socket

•Pliers

•Safety glasses

Refer to Figure 1 and install the wheel kit as follows:

Unpack the Generator

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Figure 1 — Install Wheel Kit

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Place a wheel on each side as shown in Figure 1A.

4.Place a washer on axle and then place an e-ring in axle groove.

		A
		Axle
		Wheel
		Flat Washer
Capscrew	Axle
Support Leg	Wheel	E-Ring
Hex Nut

6