Troy-Bilt 1919 owner manual Remove Generator From Carton, Install Wheel Kit, Section Assembly

Section Assembly

3

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at 1-888-611-6708.

Remove Generator From Carton

1.Set carton on a rigid flat surface with “This Side Up” arrows pointing upward.

2.Carefully open top flaps of shipping carton.

3.Cut down corners at one end of carton from top to bottom and lay that side of carton down flat.

4.Remove all packing material, carton fillers, etc.

5.Remove generator from shipping carton.

Install Wheel Kit

The wheel kit is designed to greatly improve the portability of your generator.

NOTE: Wheel kit is not intended for over-the-road use. You will need a socket wrench with 1/2" or 13mm sockets and a needle-nose pliers to install this kit.

1.Place bottom of generator cradle on a flat, even surface.Temporarily place unit on blocks to ease assembly.

2.Slide axle through both axle mounting brackets on cradle frame, as shown in Figure 1.

3.Slide a wheel over axle.

NOTE: Be sure to install both wheels with the air pressure valve on the outboard side.

4.Place e-ring onto groove in axle.You may add the flat washer if desired.

Figure 1 — Install Wheel Kit

Cap Screw
Hex Nut
		Flat Washer
Handle Assembly	Axle
Support Leg	Cap Screw
Hex Nut	Wheel	E-Ring

6