Section 4: Operation
•For general rinsing (medium pressure and medium flow), ideal for most all purpose cleaning such as home siding, brick patios, wood decks, driveways and sidewalks, garage floors, etc., select orange General ProjectPro™ nozzle (Figure 16).
Figure 16 — General Nozzle
•For maximum rinsing (higher pressure and lower flow), for stubborn or hard to reach surface such as second story surfaces, paint removal, oil stains, rust removal or other stubborn substances (tar, gum, grease, wax, etc.), select red Max ProjectPro™ nozzle (Figure 17).
Figure 17 — Max Nozzle
•To apply detergent, applies project specific cleaners to help break down stubborn dirt and grime on a variety of surfaces, select black ProjectPro™ cleaning detergent nozzle (Figure 18).
Figure 18 — Cleaning Detergent Nozzle
4.Pull back on collar, insert selected ProjectPro™ nozzle and release collar.Tug on ProjectPro™ nozzle to make sure it is securely in place.
5.For most effective cleaning, keep ProjectPro™ nozzle from 8 to 24 inches away from cleaning surface. If you get the nozzle too close, you may damage the cleaning surface.
6.DO NOT get closer than 6 inches when cleaning tires.
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a rapid circular pattern. Always start the turbo nozzle at a distance, gradually getting closer to the surface until you get the cleaning force you want.
CAUTION
The turbo nozzle produces an extremely high pressure spray which is capable of removing paint and cutting holes through surfaces if held too close.
•Always make sure the surface you will clean will not be damaged by the high pressure spray by testing in a hidden area.
1.Pull back collar on
2.Pull back on collar, insert turbo nozzle and release collar (Figure 19).Tug on turbo nozzle to make sure it is securely in place.
Figure 19 - Attaching Turbo Nozzle to Nozzle Extension
3.For most effective cleaning, keep turbo nozzle from 8 to 24 inches away from cleaning surface. If you get turbo nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with turbo nozzle.
How to Use the Rotating and Utility Brushes
The rotating and utility brushes allow you to scrub surfaces with water filtering through the bristles.
To attach a brush to the gun:
1.Remove nozzle extension from spray gun, if attached.
2.Attach brush to spray gun.Tighten by hand (Figure 20).
13