![](/images/new-backgrounds/1116453/11645319x1.webp)
•Rotate the coupling end of the cable counterclockwise to provide more slack.
•Retighten the hex jam nut. See Figure 7.
•Repeat Auger Control Test to verify proper adjustment has been achieved.
Auger |
Control |
Jam Nut |
Auger |
Control Cable |
Figure 7
Chute Clean-Out Tool
The chute
•Release both the Auger Control Lever and the Traction/Auger Control Lock Lever.
•Stop the engine by removing the ignition key.
•Remove the
•Use the
WARNING: Never use your hands to clean snow and ice from the discharge chute or auger housing
•Refasten the
•While standing in the operator’s position (behind the snow thrower), engage the auger clutch lever for a few seconds to clear any remaining snow and ice from the discharge chute.
Drift Cutters (If Equipped)
Drift cutters should be used when operating the snow thrower in heavy drift conditions.
On models so equipped, drift cutters are assembled to the auger housing inverted. Remove the carriage bolts by unthreading the hex nuts which secure them, and reinstall the drift cutters in their proper position before operating the snow thrower. See Figure 8.
If your unit is not equipped with drift cutters, contact Customer Support as instructed on page 2 for information regarding price and availability.
Snow Thrower Model | Drift Cutter Kit |
All models |
|
Drift |
|
Cutter |
|
Carriage Screws |
|
& Hex Nuts |
|
Figure 8
Operating Tips
NOTE: Allow the engine to warm up for a few minutes. The engine will not develop full power until it reaches operating temperature.
WARNING: The temperature of the muffler and the surrounding areas may exceed
150°F. Avoid these areas.
•For the most efficient snow removal, remove snow immediately after it falls.
•Discharge the snow downwind whenever possible.
•Slightly overlap each previous path.
•Set the skid shoes 1/4" below the shave plate for normal usage. The skid shoes may be adjusted upward (to lower the shave plate) for
•Be certain to follow the precautions found in the To Stop Engine section to prevent possible
•Clean the snow thrower thoroughly after each use.
10