Assembly (continued)

Shaft Housing

Pre-drilled Hole

 

Bottom Clamp

Fig. 2-2

Anti-rotation screw

 

J-Handle

 

(4) Screws

Top Clamp

Middle Clamp

 

Bottom Clamp

 

Fig. 2-3

Nuts

 

 

Decal

Fig. 2-4

Fig. 2-5

INSTALLING AND ADJUSTING THE J-HANDLEInstalling

1.Remove the screws, nuts, clamp pieces that were installed on the J-handle for shipping.

2.Lay the unit on its side. On the bottom of the shaft housing is a pre-drilled hole. With a Flat Blade or Torx T-20 Screwdriver, insert the Anti-Rotation Screw through the hole in the bottom clamp and into the hole in the shaft housing (Fig. 2-2). Tighten securely.

3.Place the J-handle between the top and middle clamp pieces (Fig. 2-3).

4.While holding the three pieces together, install the four (4) screws through the top clamp and into middle clamp.

NOTE: The holes in the top and middle clamp will line up only when assembled correctly.

5.Place the clamps and J-handle the over the shaft housing and onto the bottom clamp.

6.Hold each hex nut in the bottom clamp recess with a finger. Start screws with a large Phillips screw- driver. Do not tighten until you make the handle adjustment.

Adjusting

7.Loosen the screws so that the J-handle can be easily moved in the clamp assembly. Do not remove the screws or nuts.

8.Slide the J-handle in or out until the arrow/white line on the decal touches the clamp assembly (Fig. 2-4).

9.While holding the unit in the operating position (Fig. 2-5), position the J-handle to the location that provides you the best grip.

10.Tighten the clamp screws evenly, until the J-handle is secure.

7