| TROUBLESHOOTING |
|
|
|
|
MOTOR WILL NOT START |
|
C A U S E | A C T I O N |
Unit is unplugged | Check cord to make sure it is still plugged into an electrical outlet |
Overload protection switch has popped | Reset overload protection switch |
| |
CUTTING ATTACHMENT WILL NOT ADVANCE LINE | |
C A U S E | A C T I O N |
Cutting attachment bound with grass | Stop the unit and clean cutting attachment |
Cutting attachment out of line | Refill with new line |
Inner reel bound up | Replace the inner reel |
Cutting head dirty | Clean inner reel and outer spool |
Line welded | Disassemble, remove the welded section and rewind |
Line twisted when refilled | Disassemble and rewind the line |
Not enough line is exposed | Push the bump knob and pull out line until 4 inches (102 mm) of line |
| is outside of the cutting attachment |
| |
CUTTING LINE ADVANCES UNCONTROLLABLY | |
C A U SE | A C T I O N |
Oil, cleaner or lubricant in cutting head | Clean and thoroughly dry the cutting head |
If further assistance is required, contact your authorized service dealer.
14