OPERATING INSTRUCTIONS

CONNECTING THE CORD

Use the cord hook when connecting the extension cord to the power cord outlet. This helps prevent any disconnection.

1.Make a narrow loop with the extension cord.

2.Push the loop through the opening and move it onto the hook on the motor housing (Fig. 9).

3.Plug the cord properly into the socket.

Only use outdoor-approved extension cords. Cord sets are specified in the Important Safety Information section.

Fig. 9

STARTING/STOPPING INSTRUCTIONS

Once the unit is plugged in, stand in the operating position (Fig. 11). Squeeze the trigger to start the unit. To stop the unit, release the trigger (Fig. 10).

WARNING: Always wear eye, hearing, foot and

body protection to reduce the risk of injury when operating this unit.

Trigger

Fig. 10

OPERATING THE TWO-SPEED SWITCH

This unit is equipped with a two-speed switch. The switch has a powerful high speed for demanding yard work, and a precision low speed for light-duty yard work.

Push the switch up for high speed trimming, down for low speed trimming (Fig. 10).

CAUTION: Do not use the unit for demanding work with

the switch in the low speed. This could cause overheating and failure.

HOLDING THE UNIT

Before operating the unit, stand in the operating position (Fig. 11). Check for the following:

•The operator is wearing eye protection and proper clothing

•With a slightly-bent right arm, the operator’s hand is holding the shaft grip

•The operator’s left arm is straight, the left hand holding the D-handle

•The unit is at waist level

•The cutting attachment is parallel to the ground and easily contacts the grass without the need to bend over

Fig. 11

ADJUSTING TRIMMING LINE LENGTH

The Bump Head™ cutting attachment allows you to release trimming line without stopping the motor. To release more line, lightly tap the cutting attachment on the ground (Fig. 12) while operating the trimmer at high speed.

NOTE: Always keep the trimming line fully extended. Line release becomes more difficult as cutting line becomes shorter

Each time the head is bumped, about 1 inch (25.4 mm) of trimming line releases. A blade in the cutting attachment shield will cut the line to the proper length if any excess line is released.

9