True Food Service Equipment, Inc.
MAINTENANCE, CARE & CLEANING
CLEANING THE CONDENSER COIL
TOOLS REQUIRED:
•Phillips Screwdriver
•5/64" Stiff Bristle Brush
•Adjustable Wrench
•Vacuum Cleaner
STEP 1
Unplug or disconnect power to the cabinet.
STEP 2
Take off rear lower grill assembly by removing two (2) bottom screws.
If necessary, loosen screws holding the top pivot pins. Swing grill up and remove frame hooks from pivot pins at top of louver.
STEP 3
Remove bolts anchoring compressor assembly to frame rails and care- fully slide out. (tube connections are flexible).
STEP 4
Clean off accumulated dirt from condensing coil with a stiff bristle brush.
STEP 5
Lift cardboard cover above fan at plastic plugs and carefully clean condenser coil and fan blades.
STEP 6
After brushing condenser coil vacu- um dirt from coil, and interior floor.
STEP 7
Replace cardboard cover. Carefully slide compressor assembly back into position and replace bolts.
STEP 8
Reinstall louver assembly onto unit, tighten all screws.
STEP 9
Connect unit to power and check to see if condensing unit is running.
12 | www.truemfg.com | 12 |