True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
STORAGE BINS
A.Bins can be arranged in different layouts for preferred placement.
B.Remove bins and adjust cross bars for desired placement. (See images
Image 1
Image 2
DRAWER ALIGNMENT
A.For drawer face alignment four screws are located on the back of the drawer face. (See image 3).
B. Loosen these four screws and adjust the drawer face aligning with the rest of the drawers. Anchor the four screws once alignment is achieved.
Image 3
ELECTRICAL INSTRUCTIONS
A.Before your new unit is connected to a power supply, check the incoming voltage with a voltmeter. If anything less than 100% of the rated voltage for operation is noted, correct immediately.
B.All units are equipped with a service cord, and must be powered at proper operating voltage at all times. Refer to cabinet data plate for this voltage.
TRUE requires that a sole use circuit be dedicated for the unit. Failure to do so voids warranty.
WARNING
Compressor warranties are void if compressor burns out due to low voltage.
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - Remove front louvered grill, wiring diagram is positioned on the inside cabinet wall.
7 | www.truemfg.com | 7 |
