True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
ELECTRICAL INSTRUCTIONS
Step 4
A.Before your new unit is connected to a power supply, check the incoming voltage with a voltmeter. If anything less than 100% of the rated voltage for operation is noted, correct immediately.
B.All units are equipped with a 7 ft. (2.1m) service cord, and must be powered at proper operating voltage at all times. Refer to cabinet data plate for this voltage.
True requires that a sole use circuit be dedicated for the unit. Failure to do so voids warranty.
WARNING
Compressor warranties are void if compressor burns out due to low voltage.
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - locate the diagram inside large junction box on top of unit.
STARTUP
Step 5
A.The compressor is ready to operate. Plug in the cooler.
B.Temperature control set at No. 4 position gives refrigerators an approximate temperature of 35°F and freezers an approximate temperature of
C.Excessive tampering with the control could lead to service difficulties. Should it ever become necessary to replace temperature control, be sure it is ordered from your True dealer or recommended service agent.
D.Good air flow in your True unit is critical. Be careful to load product so that it neither presses against the back wall, nor comes within four inches of the evaporator housing (Interior Top). Refrigerated air off the coil must circulate down the back wall.
NOTE
If the unit is disconnected or shut off, wait five minutes before starting again.
RECOMMENDATION
Before loading product we recommend you run your True unit empty for two to three days. This allows you to be sure electrical wiring and installation are correct and no shipping damage has occurred. Remember, our factory warranty does not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for your cooler. If at any time during the life of your cooler, a part is needed, you may obtain this part by furnishing the model number and serial number to the company from whom you purchased the cooler. Call
DIGITAL TEMPERATURE DISPLAY
The digital temperature display can view ˚C or ˚F. To achieve this, there is a small plug that will need to be removed to achieve ˚C reading. See image 1
for temperature display location. If the plug is kept in the back of the digital display ˚F will be viewable. See images for reference. When temperature display is in ˚C mode place the plug in a safe place so it can be easily reinstalled for ˚F reading.
˚F
Image 1 (Rear of Rainshield)
˚C
| Image 2 | Image 3 |
9 | www.truemfg.com | 9 |
