TTE Technology L22HD32D owner manual Power source, Inserting Batteries, Operation, To USE AC Power

Remote control			(continued)
Inserting Batteries
1 Open the battery compartment		2 Install two “AAA” batteries,	3 Replace the compartment cover.
	cover in the direction of the arrow.	paying attention to the
		polarity diagram in the battery
		compartment.
Operation
•	Aim the remote control at the remote sensor and press control
	buttons to operate.
•	Operate the remote control within a 30° angle on either side of		Approximately 15 feet
	the remote sensor, up to a distance of approximately 15 feet.

NOTE:

•Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.

•The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote sensor may shorten operating distance.

•Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries properly.

•Do not mix old and new batteries.

•Remove batteries if the remote control will not be operated for an extended period of time.

Power source

TO USE AC POWER

1.Connect the AC cord plug into this unit’s AC IN jack.

2.Connect the AC cord into an AC outlet.

AC Outlet

Wider Hole

and Blade

AC 120V, 60Hz

AC cord (supplied)

NOTE:

•Please make sure to insert the cord securely at both the LCD TV/DVD and the wall outlet.

•The AC Cord has a grounding-type AC line plug. If the supplied AC cord does not match your AC outlet, contact a qualified electrician, do not defeat the purpose of a grounding plug.

WARNING:

•DO NOT CONNECT THIS UNIT TO THE POWER USING ANY DEVICE OTHER THAN THE SUPPLIED AC CORD. THIS COULD CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.

•DO NOT USE WITH A VOLTAGE OTHER THAN THE POWER VOLTAGE DISPLAYED. THIS COULD CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.

CAUTION:

•WHEN THIS UNIT IS NOT USED FOR A LONG TIME, (E.G., AWAY ON A TRIP) IN THE INTEREST OF SAFETY, BE SURE TO UNPLUG IT FROM THE AC OUTLET.

•DO NOT PLUG/UNPLUG THE PLUG WHEN YOUR HANDS ARE WET. THIS MAY CAUSE ELECTRICAL SHOCK.

•IF YOU NEED TO REPLACE THE SUPPLIED AC ADAPTER OR AC CORD, THE SPECIFIED ONE IS RECOMMENDED. CONTACT THE DEALER THAT YOU PURCHASED THE UNIT FROM.

12

51H0101A_eng.indd 12

08.3.12 4:51:07 PM