Tunturi Alpha 150 owner manual Maintenance, Set

5.7 SET

1.To set the heart-rate limit press SET once. The lower heart rate limit is indicated by the text LO and the upper limit by HI. If desired, the user interface indicates when your heart rate falls

below the lower limit or exceeds the upper limit with an alarm. To set heart rate limits procede as follows:

::The lower limit (LO) may be set between 50 and 220 beats per minute. Use the - or + keys to set the value and press OK to confirm. Set the upper heart-rate limit (max. 220) in the same way as for the lower limit. Press OK to confirm.

::To delete heart-rate limits use the - or + key to move the values above the permitted upper or lower limit. The value is then replaced by — on the display.

2.To select the alarm press SET twice. The text Ind OFF indicates that the alarms are switched off and Ind ON that they are switched on. Use the - or + keys to select OFF or ON and press OK to confirm.

3.To set units of measurement press SET three times.

::Default units are rpm, km and kcal.

::To change the units press the + or - key until the desired units are displayed.

::To measure speed you can set either revolutions per minute, (rpm), kilometres per hour (km/h) or miles per hour (mph). Energy consumption measurement can be set for kilocalories (kcal) or kilojoules (kJ).

::In addition to rpm you can also select either kilometres (km) or miles as distance measures. If km/h is selected as the unit to measure speed, km will automatically be the unit for distance. The same applies to the units mph and miles.

::Press OK to confirm your selections, which are then saved and indicated on the main display.

::Press the RESET key to exit the setting function without saving the adjustment. This resets the readings on the main display.

10 ::

6. MAINTENANCE ::

::In training, T.I.E. interface tolerates an environment measuring +10°C to +35°C. A T.I.E. interface can be stored in temperatures ranging between -15°C and +40°C. Air humidity in the T.I.E. interface training or storage environment must never exceed 90 %.

::Press the keys with the tip of the finger; your nails may damage the key membrane.

::Do not let the T.I.E. interface come into contact with water. Always dry the surface of the interface, if there are any drops of sweat on it. Use a soft, absorbent cloth. Do not use solvents to clean the user interface surface.

::Protect the user interface from excess sunlight: it may fade the colours of the user interface box and surface membrane.

::Please contact your dealer immediately if you notice any defects or malfunctions while using your T.I.E. interface. Please state the nature of the problem, conditions of use, purchase date and serial number of your T.I.E. interface. The location of the serial number sticker is shown on the inside cover.

::At the end of this manual, you’ll find a diagram and list of spare parts for the Alpha 150.

::T.I.E. user interfaces meet the requirements of the EU’s EMC Directives on electromagnetic compatibility (89/336/EEC) and electrical equipment designed for use within certain voltage limits (73/23/EEC). This product therefore carries the CE label.

NOTE! The instructions must be followed carefully in the assembly, use and maintenance of your equipment. The warranty does not cover damage due to negligence of the assembly, adjustment and maintenance instructions described herein. Changes or modifications not expressly approved by Tunturi Oy Ltd will void the user's authority to operate the equipment!

Due to our continuous policy of product development, Tunturi reserves the right to change specifications without notice.

We wish you many enjoyable training sessions with your new Tunturi training partner!

:: 11